For some time now in my head is spinning thinking about how to put home LED light bulb, where there are regular spotlights, whose base JCDR. Generally, it is thought to put LED bulbs in street lighting to the evening covered playground in front of the door - it will be more economical than any galogenka. Of course, now you can freely buy LED bulbs in any major hardware store, however, prices for these products democracy is not democratic, I'll tell you. LED lamp, about which I shall tell you, was the most expensive, which I saw. Generally, this lamp is low power, 1.2 watts, so the price is low. However, once decided to search the internet high brightness LED lamps, and I still want to tell you that the pleasure is too expensive, that we ordinary people to buy them 
Roughly speaking, normally if the LED lamp power of 7 watts stand that way 1000 rubles (approximately). I am still yet profitable conventional halogen incandescent lamp (JCDR - GU5.3) even though she and a glutton. On the other hand, energy-efficient LED bulbs at 220V can recapture the cost of electricity over time. Because the lamp 2w saves electricity better than lamp 35w. Actually, I think that soon, as LED lamp, China set to stream, and the production of light bulbs will go in each province they will drop enough to mass purchases do not hesitate to buy in the store LED lamps instead of halogen.
In general, the base LED lamps is different, but you want me to GU 5.3 JCDR was only in one store. In another they were, but небыло white and blue houses and green light does not suit me
Here are the characteristics of this lamp:
Manufacturer: YUSING
Type: LED
Number of diodes: 18 pieces
Capacity: maximum - 2 watts
Cap: JCDR GX 5.3 (analogue GU 5.3, but the lamp a little wider, and for some lamps must be checked intermeddle or not)
Voltage: 220 Volts
Average lifetime: 50,000 hours. (Approximately 6 years of work, as it is written on the package)
Class cost: A (most economical)
Manufacture: China
Made at home lighting wall, the so-called point-lights. And the spotlights - it is built halogen lamp with reflector type JCDR, and with a base GU5.3. We have been calculated on the lamp 12B, for reasons of safety, for 220 all the same dangerous strain. But to connect the tubes for 12 v requires a special scheme to connect halogen lamps with a transformer to power halogen lamps that converts 220v to 12 volt. However, for some reason burned for 2 transformer, although the tubes were connected to it in the sum on the 120w, and the transformer was designed for 150-200 watts. Вобщем, last burned transformer was the last straw of patience. It was decided to alter the wiring under the halogen bulb 220V, because the transformers are a little more than a set of halogen lamps at 220 volts. Yes, and chuck a halogen lamp that for the same 12 that for 220 volts. The store was spotted halogen bulb Navigator on 75 watts, and it was decided to try it in use. As a result, we were afraid to put it into the wall. The reason - a very high heat, it is virtually a small stove. After 5 minutes of work there is the smell of wires that fit in the tube, indicating that a decent heating, and high fire risk. Later we decided to search or LED lamps for 220V, or take on the halogen 50w or 35w, although the brightness will be smaller.
Halogen bulb Navigator - Response:
* Halogen bulb. Use for lighting.
* JCDR type reflector halogen
* Power 75 W
* Diameter 51 mm
* Cap GU5.3
* 230V
* Site of the manufacturer: www.navigator-light.ru
* Manufacturer - China, packed (as barcode ) in Russia.
